If you start multiple connections when in Full Control or View Only mode, the sessions are open in tabs: Since both Full Control and View Only modes use the same window, you can quickly tell in which mode you are currently in by looking at the icon state (pressed for Full Control and not pressed for View Only).Īlternatively, you can use Alt + F12 keyboard shortcut to switch between Full Control and View Only modes. Just use the toggle icon ( ) on the toolbar. You can quickly alternate between Full Control and View Only modes without closing the window. The View Only window will open: Alternating between Full Control and View Only So for persistent changes it may be more beneficial to generate a nf file that is not used by default in RHEL 6 and 7.Alternatively, right-click on the connection icon and select View Only from the menu: Additionally, the settings will be lost after the session is restarted (logout or reboot).Make certain that the display is "connected" as the output from the query above shows.Verify the display for the X11 session reflects the targeted resolution change.In this instance, to change the resolution the first display on run the command below: From the above see that there are 2 displays connected to the system with the various display sizes detected and listed.From here check the display sizes that the display driver can detect will work using the monitor.To switch the desired display resolution, list the detected resolutions for the display by running the following command:.Is there an alternative solution to modifying the display configuration in RHEL ?.The past method of changing display resolution was to use the system-config-display application.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |